The information in the right pane changes. Below the device, select a logical partition. Select a device and read the detailed information about the device in the right pane. For example the second device will be shown as Hard Disk 1. Subsequent hard drive devices are numbered consecutively. A system with a single hard drive shows as number 0. Hard drive devices are numbered by the system BIOS. A list of commands is displayed below the device list. Change the position of the cursor in the list using the keyboard and arrow keys.The Detected Physical Devices screen appears.Īll system physical devices and logical partitions are displayed in a list. At the DOS prompt, run KillDisk for Hard Drives by typing: KILLDISK.EXE.The screen will display the Microsoft DOS prompt. With the PC power off, insert either the KillDisk bootable USB / floppy disk into drive A: or the KillDisk bootable CD into your CD-ROM drive. Here are the steps for interactive operation: If you are booting from a CD, check that the CD drive has boot priority in the BIOS settings of your computer. If you are booting from a USB / floppy drive, check that the USB / floppy drive has boot priority in the BIOS settings of your computer. Follow steps 1 through 13 and then click the link to complete either the erasing process or the wiping process. The steps for erasing data and wiping data are similar. For "hands-off" operation, see 3.3.3 Autoexecute Mode. This section describes how to use the DOS Interactive screens. In Autoexecute Mode, however, KillDisk for Hard Drives will start immediately upon completion of the bootstrap startup (depending on the automatic settings). It is wise to label the USB / floppy to identify the way you plan to use KillDisk for Hard Drives.ĭOS Interactive Mode and Command Line Mode are similar in that you can control what happens after the utility has started.
0 Comments
Leave a Reply. |